Search results
From Tinkla: Tinkering with Tesla
- |style="color: red;" |OFF |style="color: red;" |OFF13 KB (2,183 words) - 18:41, 8 December 2023
- ...is screw on the right, and a corresponding one on the left below the dash (red arrows). ...e box behind the passenger kick panel and you'll need to re-crimp your 12v red wire which will make this about an hour install.5 KB (969 words) - 13:43, 6 September 2020
- # adding the pins 1 (red) and 9 (black) to the existing OBD2 connector3 KB (620 words) - 18:04, 29 June 2023
- ...side of the dash where the door meets the dash. There is a screw in here (red arrow) that holds the top dash trim to the frame which is essential to remo4 KB (760 words) - 13:43, 6 September 2020
- ...passenger kick panel (2016 and later) and you'll need to re-crimp your 12v red wire for an hour install, or (c) if you don't have a fuse box in the cabin ...return you should see two flashing green LEDs on the Tinkla Buddy and one red flashing LED.9 KB (1,572 words) - 14:22, 13 March 2023
- # Remove the RED protective tape from the back of the 3M adhesive and be ready to place the '''<span style="color: red;font-size: 18pt;">DON’T INSTALL ON ANYTHING OTHER THAN A TESLA!</span>'''10 KB (1,761 words) - 16:51, 10 November 2023
- ...e|Giraffe's]] EPAS connector and then the EPAS Harness into the male JST2. Red should be CAN+ and black should be CAN- (that's the convention also used in If you still experience red PRND letters after a successful flash and pedal being in operational mode,12 KB (2,034 words) - 17:05, 26 March 2022
- ...the spring clip to release the JST2 connects and then insert black in the red position and vice-versa, the plug the JST2 cable back into the giraffe, put6 KB (1,101 words) - 16:36, 19 September 2020
- # Remove the RED protective tape from the back of the 3M adhesive and be ready to place the '''<span style="color: red;font-size: 18pt;">DON’T INSTALL ON ANYTHING OTHER THAN A SUPPORTED TESLA!15 KB (2,595 words) - 18:20, 1 April 2022
- * Red - 5V10 KB (1,684 words) - 18:11, 1 September 2022
- Warning for Giraffe Rev B: Some jst2 cables have red/black set up so they won't match can+/can- on giraffe. So make sure can+ go * the place where your two new arches intersect will be point B (see red lines in diagram)24 KB (3,492 words) - 16:46, 26 March 2022
- * the place where your two new arches intersect will be point B (see red lines in diagram)12 KB (2,130 words) - 21:54, 4 January 2023