Difference between revisions of "Template:Flashing the Panda"
From Tinkla: Tinkering with Tesla
(Created page with "Most of the OpenPilot updates (or when installing new) require you to also update the software on your Panda. Here's how: In your Tesla while it says “Car Off” connect yo...") |
|||
| Line 5: | Line 5: | ||
killall boardd | killall boardd | ||
make clean | make clean | ||
| − | make | + | make && sleep 1 && (make recover || make recover) && echo Success! Rebooting in 2s... && sleep 2 && reboot |
| − | make recover || make recover | + | </source> |
| − | + | The kill command ensures that there's no activity on the CAN bus. That's also why a reboot is needed at the end. If any error occurs (which of course should not happen) the reboot will be skipped so you can troubleshoot. | |
Revision as of 07:44, 18 November 2019
Most of the OpenPilot updates (or when installing new) require you to also update the software on your Panda. Here's how:
In your Tesla while it says “Car Off” connect your Panda to your Giraffe rev B OBD (or EPAS OBD). Connect your EON to the Panda via USB. Then SSH in and run:
cd /data/openpilot/panda/board
killall boardd
make clean
make && sleep 1 && (make recover || make recover) && echo Success! Rebooting in 2s... && sleep 2 && reboot
The kill command ensures that there's no activity on the CAN bus. That's also why a reboot is needed at the end. If any error occurs (which of course should not happen) the reboot will be skipped so you can troubleshoot.
