Difference between revisions of "Template:Getting Started"
From Tinkla: Tinkering with Tesla
(→Installing Giraffe) |
|||
| Line 8: | Line 8: | ||
== Installing a Giraffe == | == Installing a Giraffe == | ||
| − | There are currently | + | There are currently three options concerning Giraffes for your Model S. |
# Giraffe revC from @AsianTea#7596 on the [https://discordapp.com/invite/Wyna3qy Comma.ai discord] | # Giraffe revC from @AsianTea#7596 on the [https://discordapp.com/invite/Wyna3qy Comma.ai discord] | ||
#* This solution doesn't need any modification to perform a Radar retrofit. | #* This solution doesn't need any modification to perform a Radar retrofit. | ||
| Line 14: | Line 14: | ||
#* This path doesn't require a Giraffe. | #* This path doesn't require a Giraffe. | ||
#* But this will require a 120 Ohm resistor if you want to install a Radar retrofit. | #* But this will require a 120 Ohm resistor if you want to install a Radar retrofit. | ||
| − | |||
# Giraffe For cars built before May 31, 2013, will need a "TDC Connector". | # Giraffe For cars built before May 31, 2013, will need a "TDC Connector". | ||
| + | #* | ||
| + | |||
| + | Whichever one of these you end up using, install it into the corresponding port under the dash, by the driver's side door. | ||
| − | |||
== Installing EON == | == Installing EON == | ||
Revision as of 04:22, 16 December 2019
Work in Progress
This page is the first pass at replacing the Main Page "Getting Started" section.
Contents
Quick Start
If you are looking to get your EON up and running see the following guides
Installing a Giraffe
There are currently three options concerning Giraffes for your Model S.
- Giraffe revC from @AsianTea#7596 on the Comma.ai discord
- This solution doesn't need any modification to perform a Radar retrofit.
- An EPAS harness from Flyboy222pa
- This path doesn't require a Giraffe.
- But this will require a 120 Ohm resistor if you want to install a Radar retrofit.
- Giraffe For cars built before May 31, 2013, will need a "TDC Connector".
Whichever one of these you end up using, install it into the corresponding port under the dash, by the driver's side door.
