Template:Getting Started

Work in Progress
This page is the first pass at replacing the Main Page "Getting Started" section.

Quick Start
If you are looking to get your EON up and running see the following guides

Installing the Giraffe

The Tesla Giraffe install guide will start your journey to driving with OpenPilot.

Installing the EPAS Cable

Steps to make and install the EPAS Harness.

Installing the EON

Steps to install the EON and also how to install OpenPilot.

Installing OpenPilot for Tesla on the EON

Steps to perform OP install

First OpenPilot Drive

1. Make sure the EON is mounted properly and connected to the Panda by following #Installing the EON
2. Make sure the EON has Internet access (either your wifi at home or a SIM card). Connect to a mobile hotspot if you don't have a SIM card
   1. Reboot your EON before turning your car on for good measure
3. Turn your car on and verify that the Panda LEDs are pulsing red/blue/purple. If they are green, your panda is not flashed, see flashing instructions here Panda Flashing.
4. OpenPilot should switch to "drive mode" and show the camera view with white lane marking
5. Make sure that your EON is connected to the Internet or Calibration will not start
6. Read up and understand the controls from Using adaptive cruise control

IF YOUR CAR IS RECOGNIZED:

1. Calibration will increment at above 15mph. It will take less than 30 seconds to fully calibrate. If you move the mount, it's recommended to reset camera calibration under "device settings".
2. When driving, Double Pull the Cruise Control Stalk to use OpenPilot

IF YOUR CAR IS NOT RECOGNIZED

1. Ask for help on the #tesla channel of the Comma.ai Discord