Difference between revisions of "AP2 Harness"

From Tinkla: Tinkering with Tesla
m
m
 
Line 3: Line 3:
 
or
 
or
  
build your own for about $420 + tools and a lot of crimping :)
+
build your own for about $440 + tools and a lot of crimping :)
  
 
== Two Options ==
 
== Two Options ==

Latest revision as of 16:38, 1 September 2022

For the best experience, just purchase our Tinkla OBD-C Adapter for Tesla with AP2+ for $150 from our online store

or

build your own for about $440 + tools and a lot of crimping :)

Two Options

  • AP2 controls steering using the Chassis CAN and acceleration/braking through the Powertrain CAN, thus it requires two harness for complete control from OpenPilot.
  • Only a Comma three can control multiple pandas using the additional USB-C port. Hence a Comma two can only handle lateral control.

Using OpenPilot with just lateral control

  • When using the OpenPilot on a Tesla with AP2/2.5/3, you have the option to configure the software (via the UI toggles) to only do lateral control, and let the built in adaptive cruise control handle the longitudinal control.
  • To do this, you will need a Comma two or Comma three plus a Lateral Control Harness by following the instructions in the Comma repository.

Using OpenPilot with full control

To allow OpenPilot to fully (lateral and longitdinal) control your Telsa equipped with AP2/2.5/3, you need the following:

  • A Comma three
  • A black panda (for longitudinal control)
  • Two Comma Car Harnesses for Development Vehicles
  • Connectors and pin as listed in this diagram to build both the lateral control harness and the longitdinal control harness]
  • Some quiet time to sit down and build your harnesses